05/17/2026
We finished off the full 4-speaker upgrade in this vehicle this morning.
This morning, We installed a brand new sets of rear 6x9 Pioneer TS-A697OF in this 2000 Toyota Camry. Back speakers were all gone and rotten so it was time for a good upgrade. We had to redrill 4 new holes for each speakers, use new hardware, and we also wired the speakers straight to the original plugs, same as the front doors so there was no need to spend an additional $15 on wiring adapters or cut off the original wiring. Wrapped up all wiring in electrical tape for a cleaner look and wiring is out of the way. Radio and front door speakers were done two weeks ago, so rear speakers just needed to be replaced today.
Vehicle & parts used: We’ve also listed additional equipment we’ve installed in this car 2 weeks ago.
2000 Toyota Camry
Kenwood KMM-BT318U bluetooth car radio
Kicker DSC65 6-1/2 Car Speakers - Front door
Pioneer TS-A697OF 6x9 Car Speakers - Rear Trunk
Reused radio bracket and cubby pocket
Metra 70-1761 Receiver Wiring Harness (1985-up)
Reused speaker plugs
Other info if you own the same kind of vehicle:
If you have the original OEM radio pocket and you’re installing a 2 inch radio, you may reuse that piece - this Toyota did have one, we took the pocket out of another Toyota vehicle.
If your Camry did not come with the original OEM bottom pocket and you’re putting in a standard size radio, you will need to purchase this pocket separately either online or local junkyard. Link below If you choose to order online:
- American International UPT900 Dash Kit radio pocket — however, if you’re putting in a touch screen or a 4 inch unit radio for this car, you do not need to buy the pocket, all you need is just the radio wiring adapter and reuse the radio brackets off of the stock radio.
Install applies to
1997-2001 Toyota Camry.
Thanks for viewing! Any questions, feel free to comment below or message us! Have a Great Sunday!